Decorative metal effect finish (gold, silver and derivatives) silky to the touch.

METAL ARTHE is used as a finish for walls gilding (gold leaf effect), as a special finish for columns or cornices in plaster, as walls of finishing effect with very visible metal (polished steel effect).

METAL ARTHE is inflammable, it becomes completely washable after about three weeks of the application.

 

Special acrylic emulsion, metallic pigments inalterability, UV resistant, inorganic and organic pigments, additives.

 

Sandpaper any imperfections with STUCCOMURO and apply 1 coat of FISSATIVO UNIVERSALE correctly diluted with water at a ratio of 1:5 up to 1:10 depending on the surface absorption. Leave to dry for at least 4 hours and apply 2 coats of GENYUS SPECIAL, which is a special silk paint, either white or slightly colored, correctly diluted leaving 4 to 5 hours between each coat

After 4 hours 2 coats of Primer S colored with the same color as the finished color correctly diluted, leaving 4-5 hours between each coat.

 

Each article in our color chart has been divided into 4 different grades, In order to obtain the desired color you must add in each pack of ARTHE METAL SILVER o ARTHE METAL GOLD of Lt 2.5 , the quantity of ARTHE toner as indicated in the chart below:

Application There are 3 methods of application for ArtheMETAL:
Pennellato Effect: spread a layer of ArtheMETAL with a special SPALTER DECORA tool by using irregular movements, cris crossing with brush marks the surface . After drying about 12 hours, repeat the same procedure as the first coat in order to obtain the desired brush finish and an excellent coverage of the surface.
Gold Leaf Effect: spread a layer of ArtheMETAL with a SPALTER DECORAʼ tool covering about 1 square meter at a time and immediately with the help of our special ArtheMETAL TOOL you can obtain the Gold Leaf finish. After drying about 12 hours, repeat the same procedure as the first coat in order to obtain the desired Gold Leaf finish and an excellent coverage of the surface.
Frisè Effect: spread a layer of ArtheMETAL with a SPALTER DECORAʼ tool covering about 1 square meter at a time and immediately with the help of our special ArtheMETAL TOOL go over the surfaceusing circular movements; continue until the entire surface has been covered. After drying about 12 hours, repeat the same procedure as the first coat in order to obtain thedesired brush finish and an excellent coverage of the surface. The ArtheMETAL finish can be clearly seen when the entire surface has completely dried about 4 to 5 hours after the application.